The top-quality ballistic efficiency of 410 generates perfect patterns. Consistent general performance in any weather, shot immediately after shot, ton following whole lot, would make the new 410 your reloading powder of preference.
Under no circumstances combine any two powders no matter type, brand, or source. Under no circumstances substitute any smokeless powder for Black Powder or its substitute.
I've questioned about Alliant Steel for giant pistol situations (.44 Mag and scorching .45 Colts) but I feel the situation will be the flakes are way too large and also you'd need to weigh each cartridge. :barf:
I concur, Do not run off reaming something until you have loaded enough to get self-assured within your stack peak.
They're telling it like it reall is. During the 410, there is no superior propellant than H110/W296. It can get you the highest velocities, with pressures inside of motive and it is considerably easier on scenarios than other powders and Alliant 410 is particularly hard on AA HS cases.
this is kinda "State-of-the-art reloading one hundred and one" and can be achieved once you've a grasp of What's going on firstly degree.
This really is kinda "State-of-the-art reloading 101" and can be carried out after you have a grasp of What's going on at first stage.
I believe It's really a lower volume powder but given that I have not tried using the others I do not understand how it compares. I exploit AAhs hulls, Get AAhs wads, Lil Gun, and Fiochi Primers plus the shell shoots very good even so the shot is unfastened Despite having a very good deep crimp. Any person else have this issue. Jackie B.
I sure hope it really works as I just purchased 8 kilos of it after not with the ability to get Lil'gun. And about this chilly weather difficulty, we shoot skeet in next page Boulder Jct, WI Sunlight/Wed fifty two months a calendar year.
The information supplied on this Web site is for common purposes only and doesn't represent Specialist tips. We make just about every work to make sure the accuracy and dependability of the knowledge, but we do not guarantee its completeness or suitability for any individual objective.
Your rammer tube can be set much too minimal. I have never loaded .410, but I suspect that the 30 lb. you must transfer the indicator is too much for a .410 wad. Try out ramming a wad with the clamp loose and find out if the rammer tube moves up. If it does, test a crimp. If which is much too high, lessen and champ the tube about i was reading this 50 percent way.
Whilst I have never tried out it I concur with all your considering with a 4 ball load, appears like precisely the same problem as I Formerly stated with a five pellet load of OOO buck.
I can confirm from first hand practical experience the 13gr. load is effective similar to a charm using a load of 3 @ 0.395" balls; my loads were being plastic shells but I see no purpose why it would not perform with complete size metallic shells.